ClearCom KB-212 Manuál s instrukcemi Strana 38

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 46
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 37
RS-601 BELPACK
36
To rotate the beltclip to a new position:
1. Remove the setup help label and the two retaining screws.
2. Rotate the beltclip 90
o
or 180
o
as desired.
3. Replace the screws.
The label on the beltclip is not reusable and must be replaced. You
can order a replacement label from your distributor or from the
factory.
Use the same procedure for replacing a broken or damaged beltclip.
CLEANING
To clean the surface of your beltpack, use a damp cloth and mild soap.
Remove all soap residue and excess moisture before returning to
service.
TROUBLESHOOTING
PROBLEM
Low audio level.
CAUSE
Multiple terminations on the line. Excessive
capacitance and/or resistance due to cable
length and/or gauge.
SOLUTION
If connected to more than one main station
or power supply, check that there is only
one termination per channel.
Zobrazit stránku 37
1 2 ... 33 34 35 36 37 38 39 40 41 42 43 44 45 46

Komentáře k této Příručce

Žádné komentáře